PRI trunk order
Submitted by drtester on Sat, 08/23/2008 - 1:25pm.
I'm setting up my first PRI with a Rhino R1T1 card. My provider has asked that I sequence the outbound calls to start at trunk 23, and work down to 1. They will route incoming calls starting with 1 and ascending, in hopes that there is no contention. Makes sense. How do I set my Trixbox to start at 23 and work backwards?
Solved!
Fri, 09/05/2008 - 8:53pm
I'm very surprised no one answered this. The solution was simple, but not obvious. And for others who might run into the situation, here is the solution:
By default, trixbox creates a zaptel trunk labeled "g0". You need to delete (or perhaps rename) this, and create a "G0" trunk (upper-case G). This makes it start at the last one, and work backwards.
I'm cutting over to a PRI
Thu, 09/25/2008 - 4:51pm
I'm cutting over to a PRI tomrrow for a customer. I've got 15 channels configured and have setup G0 as the outbound trunk. From what I've read Asterisk will search for the highest available inactive channel to use for the call. But I've never actually tried it before. Have you used G0 before and been succesful? Thanks.
Ronald Cherry
Member Since:
2006-11-29