Do I need to install ilbc codec?
Submitted by garyv on Wed, 12/05/2007 - 8:38am.
I have a trixbox to trixbox trunk that works fine with ulaw and/or gsm. I set allow=ilbc and removed all other codecs and now I get “all circuits are busy”, I also have jitterbuffer=yes and trunktimestamps=yes on both ends of the trunks. Do I need to install or setup ilbc? I’m running trixbox 2.2.4 and 2.2.8. I thought ilbc came already to go?
Thank you
Gary V.
Gary ... (yes this is
Wed, 08/20/2008 - 3:08pm
Gary ... (yes this is answering an old post) ...
it appears to me that one needs to manually add ...
allow=ilbc
... to the sip_custom.conf file to get ilbc enabled. i was then able to make an ilbc call.
without this it appears only ulaw & alaw are enabled (in sip_general_additional.conf - though where is this set in the web GUI ???)
insights as to where one sets up codecs in the web GUI welcome (other than in trunks ...)!
AndyN
Member Since:
2006-10-20