Home » Forums » trixbox forums » Open Discussion

TrixBox Version 2.2.10 + Asterisk 1.2.24 + TDM410P

piri
Posts: 178
 Member Since:
2007-02-08
Submitted by piri on Thu, 07/17/2008 - 5:34pm.

Hi All

I am using TrixBox Version 2.2.10 + Asterisk 1.2.24 and would like to install the new Digium TDM410P, does anyone have some simple setup instructions.

With the old card all I did was run the "genzaptelconf" command, but this seems no good on the new card.

Thanks in advance.

Regards

Piri

‹ time conditions not working right setup wip330 ›


datu503
Posts: 197
 Member Since:
2007-06-06
setup-pstn
Thu, 07/17/2008 - 5:57pm

With 2.2.10, it should be easy.
Remove TDM400P and install TDM410P
then run setup-pstn.
It should read your new card, you do a reboot and presto! Its installed!

Since you have TDM410P, then you might also consider adding the EC module.
It work wonders!

Cheers!

--

Walden, Certified FtoCC Admin & Tech
www.tech-r-us.com everythingIP
www.citivoip.com everythingVOIP



piri
Posts: 178
 Member Since:
2007-02-08
Hi datu503 When I run the
Thu, 07/17/2008 - 7:58pm

Hi datu503

When I run the setup-pstn the reponse I get is "command not found"
Any ideas ?

Regards

Piri



piri
Posts: 178
 Member Since:
2007-02-08
HELP PLEASE
Fri, 07/18/2008 - 12:49am

HELP PLEASE



Kbedford
Posts: 27
 Member Since:
2008-06-12
setup-pstn was introduced in TB2.6.1
Sat, 07/19/2008 - 8:20am

Do you get any lights on the card. Maybe being a new card you need to update your system or more accurately the zaptel drivers for it to be supported. I may be wrong because I've only used the tdm400 version.



SkykingOH
Posts: 2597
 Member Since:
2007-12-17
The 410 should work great.
Sat, 07/19/2008 - 10:41am

The 410 should work great. What version Zaptel are you running?

Is the card picked up with the command 'modprobe wct4xxp' command?

Do you have any other hardware zap interfaces in the machine? If not try a 'genzaptelconf'

Scott

--

Scott

aka "Skyking"



Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.